Bigben R16 Mode D'emploi page 13

1) Setting the clock
• In standby mode, press Clock Set [6]. The display will flash and show 0:00.
• Press HR[7] & MIN[8] to set the hour and minute.
• Press Clock Set [6] again to confirm the time.
• The clock will display in 24-hour format.
2) Dimmer control (LED Display)
• Press Dimmer [5] to control the brightness of the digits on the display.
• There are 3 levels: High level (brightness) Mid level (Dim light) Low level (dark OFF)
3) Setting the alarm
- When the device is in standby, press
starts flashing.
- Press [7] and [8] buttons to adjust Hour's value and Minute's value for alarm 1, then press [2] once
to confirm when it is done. Then the melody icon
- Press [9] buttons to adjust the melody that will play when alarm 1 is active.
[4] to increase or decrease the sound volume level. The display will show the volume
Press
level, 1~ 5, cycle from minimum to maximum sound level.
- Press [7] and [8] buttons to adjust the level for alarm output, then press [2] to confirm and exit alarm
1 setup.
- Repeat the same as above to setup Alarm 2.
4) Replace clock back-up batteries
• Insert 2 x AAA batteries. Check the polarity (+ and – at the ends of the battery) and follow the
instructions on the diagram near the battery compartment. Close the compartment door.
NOTE: Please make sure you properly dispose of batteries (see your local regulations).
5) Basic specifications:
AC 100 - 240V ~ 50 / 60 Hz AC
adaptor supplied Battery:2 X AAA UM4 (R6)
Adaptor specification
• Adaptor manufacturer name or trademark (TBA)
• Adaptor Model Number ; (TBA)
• Input voltage and frequency; (TBA)
• Output voltage, current, power
• Average active efficiency: ______%
• Efficiency at low load (10%): _____%
• No-load power consumption: _____W
[1] until the main digit with alarm 1 [12] icon of the display
will appear for melody selection.
- EN 5 -