Child-Proof Lock; End Of Programme - Beko DC 7230 Mode D'emploi

drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.

Child-proof lock

There is a child-proof lock to prevent any
programme interruption due to the pressing
of button while the programme is running.
The loading door and all buttons except
the "On/Off" button on the control panel
are deactivated when the child-proof lock is
active.
Press the "Start/Pause/Cancel" and "Cancel
audio warning" buttons simultaneously for 3
seconds to activate the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should be
deactivated. Press the same buttons for 3
sec. again to deactivate the child-proof lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/
Off button.
C
Press the relevant buttons for 3 seconds
to activate the child-proof lock. A long
beep will be heard and the child-proof lock
will be activated. A double beep will be
heard if you press any button or turn the
programme selection knob while the child-
proof lock is active. Press the buttons for 3
seconds to deactivate the child-proof lock.
Single beep will be heard and child-proof
lock will be deactivated.
A
A double beep will be heard if you turn
the programme selection knob when the
machine is running and the child-proof
lock is active. If you deactivate the child-
proof lock without returning the program
selection knob to its previous position, the
programme will be terminated since the
position of the programme selection knob
is changed. The drying light turns on and
the machine remains on hold until a new
programme is selected and the "Start/
Pause/Cancel" button is pressed.
Ending the programme through
canceling
To cancel any selected programme:
Press "Start/Pause/Cancel" button for about
3 seconds. The "Filter cleaning", "Water tank"
and "End/ Anti-creasing" warning lights will
turn on at the end of this period for reminding
purposes.
A
As the inside of the dryer will be
excessively hot when you cancel the
programme while the dryer is running,
activate the ventilation programme to cool
it down.

End of programme

The "End/Anti-creasing", "Filter cleaning" and
"Water tank" warning lights on the programme
follow up indicator will turn on when the
programme comes to an end. The door can
be opened and the machine becomes ready
for a second cycle.
Press "On/Off" button to turn off the dryer.
C
Final step of the drying cycle (cooling step)
is performed without heat application in
order to keep the items at a temperature
that would not harm them.
C
A 2-hour anti creasing programme to
prevent laundry from creasing will be
activated if you do not take the laundry out
after the programme has come to an end.
C
If you will not take the laundry out
immediately, do not stop the dryer before
the drying process is complete.
C
Clean the filter after each drying (please
see, Filter cleaning).
C
Drain the water tank after each drying
(please see, Water tank)
33 EN