Insignia NS-C3111 Guide De L'utilisateur page 12

NS-C3111 Car Stereo CD/MP3 Player
Adjustment or
mode setting
BEEP mode (to
beep when
buttons are
pressed)
SEEK mode
VOL LAST/VOL
ADJ
Viewing and setting the time
You can view the time by pressing the DISP button.
To set the time:
1 Press the PWR
2 Press and hold the DISP button until the display flashes.
3 Set the hours by turning the SEL knob to the right (clockwise).
4 Set the minutes by turning the SEL knob to the left
(counterclockwise).
Programming and using radio station presets
You can program as many as 6 radio station presets for each
available band (FM1, FM2, FM3, AM1, and AM2). After you program
a station, you can tune to the station by pressing one of the numbered
preset buttons on the front of your car stereo.
To program a radio station:
1 Press the PWR
2 Select the band you want by pressing the BD/SUB
(band/subwoofer) button to select FM1, FM2, FM3, AM1, or AM2.
The current band appears on the display.
3 Tune the radio to the station of your choice by pressing the
4 Press and hold the preset number button to which you want to
assign the station until the radio beeps once (hold the button for
about two seconds).
5 Repeat Steps 2 through 4 to program additional presets.
Options
ON
OFF (default)
Seek 1 (default)–Stops at every station
detected. Press the
again to continue.
Seek 2–Does not stop at any station
until you release the
VOL LAST (default)–Sets the volume
level to the last setting used.
VOL ADJ–A low initial volume is set and
you can adjust the volume.
button to turn on your radio.
button to turn on your radio.
button.
www.insignia-products.com
Press the SEL
knob
1 × (for more than
two seconds), then
2 ×.
1 × (for more than
two seconds), then
or button
3 ×.
or button.
1 × (for more than
two seconds), then
4 ×.
or
11