Programming Mode - Atlantic Ulysse Notice D'utilisation Et D'installation

To activate pilot wire control, position the switch A to Program
By thus connecting the pilot wire to a programmer, you can control the heating in the desired mode
(Comfort, Comfort-1°C, Comfort -2°C, Eco or Anti-Frost).
When you are in Program mode, the pilot wire only acts on the heating temperature. You continue
to switch to Turbo at the times you have selected using the pegs on the clock (except in the case of
the Anti-Frost or Stop instruction).
When you exit Program mode (switch A), the pilot wire no longer affects your device except for Stop
mode (in the case of a power cut).

6) Programming mode

This mode enables you to switch automatically from Heating mode to Turbo Max 2 h mode.
a) Set the time: turn the dial on the clock in a clockwise direction until the current time (i.e. the time
on your watch) is facing the arrow at the top on the right-hand side. Fine tune if necessary by tur-
ning the central pointer.
b) Select your daily programme: opposite the hour markings, tilt the pegs towards the inside for
Heating mode and towards the outside for Turbo Max 2 h mode (1 peg = 15 minutes operation).
c) Set the switch A to Program
Example:
You occupy the bathroom from 7:00 to 8:00 AM and 9:00 to 10:00 PM.
You programme Turbo Max 2h mode from 6:30 to 7:30 AM (8:30 if drying towels) and from 8:30 to 9:30
PM.
- It is forbidden to cover or obstruct the device's upper and lower grills completely or even partial-
ly: other wise there is a risk of overheating. If the grills should be obstructed accidentally, the devi-
ce stops automatically when the maximum safe temperature is reached.
However, the 'ON' indicator light may stay lit and the clock continues to operate.
To restart, remove the item blocking one of the device's grills and set the switch A to Stop. Wait
for approximately 15 minutes and then restart the device.
- This device is not intended for use by persons (including children) with physical, sensory or men-
tal disability, or by persons lacking experience or knowledge, unless they have received from a per-
son in charge of their safety adequate supervision or preliminary instructions on how to use the
device.
- Please ensure that children do not lean on the device or play close to it when it is operating : its
surface may be hot enough to cause burns to their skin in some circumstances, particularly becau-
se their reflexes may not yet have been acquired or are slower than those of an adult. If there is
any risk, fit a protective grill in front of the device.
- Take care not to allow any foreign bodies or paper to enter the device.
- Any work inside the device must be done by a qualified professional tradesman.
- When conducting any work on the device, it is essential that it be set to the STOP position and
have cooled down before being unhooked from its bracket.
to activate your programming.
W
ARNINGS
13
.