Table des Matières
Publicité
Manuel d'utilisation de la scie murale Pentruder RS2 et du générateur Pentpak 3 HFi - Instructions d'origine - Projet
5.3.2
Changez de chaîne sur la télécommande radio (RRC)
1.
Make sure the RRC is off.
2.
Press and hold the WS and MS switches.
3.
While still pressing the WS and MS switches,
press ON/OFF on the RRC.
4.
Release switches when the display is shown.
5.
To change channel, press and hold the WS
switch.
6.
Press + (plus) or - (minus) to change channel.
Choose any channel from 1-16.
5.3.3
Appariement de la télécommande radio (RRC) avec le Pentpak 3 (PP3)
Votre Pentpak est associé à la télécommande radio lorsqu'il est livré par votre distributeur Pentruder.
1.
Make sure the Pentpak 3 is disconnected from
the power supply.
2.
Make sure the RRC is off.
3.
Connect the RRC to the Pentpak 3 with the CE-
RRC cable for radio remote control.
4.
Make sure the emergency stop on Pentpak 3 is
out and that the stop button on
RRC is out.
5.
Turn on the RRC with the ON/OFF push button.
See display:
6.
Connect the Pentpak 3 to electrical power. See
display.
7.
Press green button on Pentpak 3
8.
Press – (minus) and hold, then press enter and
release both switches. (Blade guard symbol)
This was the previous sequence which was changed by our partner. Maybe some can be used ?
1.
Assurez-vous que le Pentpak 3 est déconnecté de l'alimentation électrique.
2.
Assurez-vous que la RRC est désactivée.
3.
Connectez la RRC au Pentpak 3 avec le câble CE-RRC pour la télécommande radio.
7.
To save the channel, press – (minus) and hold,
then press enter and release both switches.
8.
When the display with radio symbol is shown,
the channel is changed.
9.
The RRC and Pentpak 3 need to be re-paired
after changing channel. See 5.3.3
9.
Press enter again on the RRC (Blade size symbol
– no need to choose blade size)
10. Press the emergency stop on Pentpak 3
11. Press the enter button on the RRC to enter the
menu.
12. Move the "marker" using the + and – buttons to
the pairing symbol, and press enter to pair.
13. If the pairing was successful the display will go
back to D6 Cutting display.
If pairing was not successful, change channel on
14.
the RRC, see 5.3.2, and then try pairing again.
Page 32
Publicité
Table des Matières
