Control Buttons; Filter Maintenance - Aurora Vortix Vr1000 Manuel D'utilisation Et D'entretien

USE & CARE MANUAL

Control Buttons

This hood is equipped with an electronic motor and lamp control. The control is
able to set 4 different fan speeds, dim the light and has a timer function.
In the following drawing are described the main key functions.
Adjust 4 speed
On/off button: This button will turn off or on (at speed level 1) the fan.
Adjusting speed level buttons: these buttons will increase or decrease the
speed of your fan for your convenience. Note if you are at speed 1 you will not be
able to decrease the speed level fan at 0 (or off), you should use the On/Off
button.
Light button: this button will switch your light intensity through 3 levels from level
0 (or off) to level 3 (max) and go back to level 0.
Delay button: this button will allow you to activate a 10 minutes timer which will
shut off the fan at any speed after this period of time.

Filter maintenance

To make your hood ventilation efficient, it is important to clean the filters
frequently. This hood is provided with a filter clean reminder system. After 50
hours of use, the indicator Delay/Clean filters will flash, reminding you that you
should clean your filters. The filters are made in stainless steel and can be
washed by hand or in the dishwasher.
To remove the filters:
- turn off the fan and the light
- Pull the spring release handle
To reset the 50hours counter, press and hold
the on/off button until the indicator stops flashing.
PK-4101 (Rev.1)
Speed level indicator
Turn on/off
levels
Delay/Clean
filters indicator
Light (3 levels)
10 minutes
delay off
1
2
Page 2