Chapin 63924 Manuel D'utilisation Et D'entretien page 9

DISASSEMBLING AND REPAIRING THE SHUT OFF VALVE
Figure 1
A
Figure 2
Valve
Stem
C
Figure 3
Recycling Spent Battery
In some areas, it is illegal to place spent lithium-ion batteries in the trash or municipal solid
waste stream. You may also contact your local recycling center for information on where to
drop off the spent battery, or call 1-800-8-BATTERY.
1) Assembled shut-off valve (Figure 1).
2) Remove the retaining pin (A) (Figure 2) place the notched end
of the retaining pin on a hard surface and push down. Remove the
retaining pin and slide the handle off the valve.
3) Remove the retaining nut (o-ring attached), spring, and valve stem (B)
(Figure 3). Replace worn parts. Lubricate the O-rings and reassemble by
reversing the steps above. Place the handle groove in the slotted area of
the valve stem. Insert the retaining pin. Push down on the handle a few
B
times to distribute the lubricant evenly. Check filter (C) in end of shut-off
valve for debris. Remove filter and flush with water to clean out.
8E