Installing The Shoulder Strap - Chapin 63924 Manuel D'utilisation Et D'entretien

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut

INSTALLING THE SHOULDER STRAP

The top of the shoulder straps are attached to the tank.
Attach the lower end of the straps by clipping the strap hooks to the
metal frame between where the frame exits the tank and curves around.
3 STAGE FILTERING SYSTEM
This backpack sprayer is equipped with a 3 stage filtering system (see
figure 1). Stage 1 is a filter basket incorporated into the tank opening
where fluid is added. Stage 2 filter is located at the inlet of the pump
housing. Stage 2 is a removable In-Tank filter. Stage 3 is a removable filter
incorporated into the shut-off assembly. Periodic cleaning of these filters
is recommended to insure consistent fluid flow through the sprayer. This
will also reduce sprayer component wear.
The stage 3 filter is a removable filter incorporated into the inlet side of
the shut-off valve (see section "disassembling and repairing the shut-off
valve"). Make sure pump switch is off and pressure is released before
detaching the hose from the shut-off.
Figure 2 Stage 2 (removable In-Tank filter)
Guide edge facing away from
pressure cylinder
O-ring
Wand
Guide edge on pressure
cylinder
6E
Shut-off
Valve
Figure 1
Stage 2
Pump
(Removable
Housing
In-Tank Filter
Stage 3
(removable
Shut-off filter)
Stage 1
(Filter
basket)