Blades; Maintenance And Storage; Troubleshooting - Texas A/S ES 300 Mode D'emploi

8. Blades

The blades will be worn during use, and will soon or later need to be replaced.
The time of replacement depends on the conditions of the soil in which the machine works.
An extra set of blades is included with machine to extend the working time.
Replacement:
Before the knives are replaced, make sure to disconnect the
power supply first. Then loosen each blade with an allen key
wrench. Fit the new blades together with the lock washers,
And tighten the bolt.
Be careful to fix the blades in the right position.
Extra set of blades can be purchased at your local dealer
or online at www.texas.dk
Part number for a blade set (2 pcs.) is: 421117

9. Maintenance and storage

Clean all grass and soil from the machine after use.
If not to be used for an extended period of time, coat all metal parts in grease to avoid
corrosion and rust.

10. Troubleshooting

Problem
Motor will not start:
Abnormal noise
Abnormal vibrations
Poor cutting action
Use original spare parts only
Cause
No power
Defective safety button
Blade stuck
Loose bolts, nuts or safety
equipment.
Depth too great
Depth too great
Depth too shallow
Worn blade
19
Solution
Check power supply and cables
Contact authorized workshop
Switch off machine and allow it to
stop completely. Remove
obstruction.
Tighten. Contact authorized
workshop if noise persists
Replace or contact authorized
workshop
Use correct depth
Use correct depth
Replace or contact authorized
workshop