Technical Specifications - Velleman ASS4 Notice D'emploi

5. Operation
Refer to the illustrations on page 2 of this manual.
• Connect the speaker set (not incl.) outputs to an input connector pair [1, 2, 3 or 4] at
the rear of the speaker selector. Use a suitable cable (not incl.) of max. 14 gauge
(±2mm²). To make a connection:
strip ±10mm of insulation from the cable
o
twist the copper wire
o
push on the spring loaded connector
o
insert the wire
o
release the spring loaded connector
o
• Important: always use the correct polarity – connect the positive (+, red) terminal of
the speaker to the positive connector on the speaker selector and the negative (-, black)
terminal of the speaker to the negative connector of the speaker selector.
• Always connect speakers in pair (a left and right speaker) to any input connector [1, 2,
3 or 4] and use speakers with the same impedance.
• Make sure the amplifier (not incl.) is off and connect its speaker outputs to the input
connectors [D] of the speaker selector. Use a suitable cable (not incl.) of max. 14 gauge
(±2mm²) and respect the polarities.
• When desired, a second speaker selector can be connected to the output connectors [E].
• Switch on the amplifier and enable the desired output speakers with the output selectors
1~4 [B] at the front of the speaker selector (push down to enabled, release to disable).
Note: depending on the load, the speaker selector will heat up. Always leave at least
5cm free space on either side of the selector switch and keep the ventilation openings
free from dust etc ... at all times.
• When necessary, press the impedance protection circuit switch [A] to enable the internal
impedance protection circuit. This prevents that the impedance presented to the amplifier
drops below 5Ω.

6. Technical specifications

input
output
connector
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held
responsible in the event of damage or injury resulted from (incorrect) use of this
device.
For more info concerning this product, please visit our website www.velleman.eu.
The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman Components nv. All worldwide
rights reserved. No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
09/01/2009
ASS4
max 100W / channel
for 4 pairs of loudspeakers / 4-8ohm (impedance)
0.3 – 2 mm²
216 x 46.5 x 114mm
1.1kg
4
©2008 Velleman ® Components nv