Cleanliness; Conformity - SMT SL 15 Notice Technique


SMT

5.1

Cleanliness

Ensure that the cleanliness of this product is maintained. In order to do this :

Regularly clean the outside of the pressure reducer with lint-free cloth and alcohol (all other
cleaning methods are prohibited).

The indicator pressure of gauges may have incompatibilities with isopropyl alcohol. When cleaning
these, use ethyl alcohol (ethanol).

The inside of the pressure reducer must not be cleaned (this operation is carried out at the factory).
However, it is recommended to flush the pressure reducer with a neutral gas before putting it into
service, or after a long storage period.
6.

CONFORMITY

SMT products (supply board, pressure regulator, valves, etc) satisfy to requirement of article 4 §3
of 2014/68/UE directive concerning pressurized equipment (PED).
ATTENTION
!
These equipments integrate pressure relief valve or safety which shall not be « CE » marked,
according to paragraph 2 of annex II.
In other case, pressure relief valves and safety devices shall be « CE » marked.
reserves the possibility at any time to change technical contents without previous consent
INSTRUCTION MANUAL
SL/SI 15 PRESSURE REGULATORS
These equipments shall not be « CE » marked
As defined in article 18.
SMT - 5, rue de Labergement - BP10 - F-21110 GENLIS
NT 0004GB
Révision : 9
30/06/2015
Page 13/ 19