Cleaning And Maintenance - Nemaxx VKM0325LED Mode D'emploi Original

The correct setting is determined by extending and retracting the awning multiple times. Check to make sure
that the front cover (6) cleanly meets the cassette (2) of the awning.
6
6
● If the awning becomes wet, extend as soon as possible to allow it to dry. Unsightly spots may appear if wet
awning fabric is rolled up for longer periods of time.
● The awning fabric can be cleaned by dry brushing. Remove persistent dirt and stains with warm soapy
water and a brush. Allow fabric to dry before retracting.
● Clean metal surfaces with a soft, damp cloth.
● Clean the remote control with a soft, dry cloth.
Never clean the awning cloth with chemicals.
WARNING!
● Risk of injury! The awning's hinged arms are assembled under very high spring tension. The
awning should not be disassembled as this may cause serious injury. Please contact your service
partner if the hinged brackets do not function properly.
NOTE:
● Operating the motor! In the event of overheating caused by frequent use, the thermal protection
function may switch the motor of the awning off. In this case, you should wait approximately
30 minutes until you operate the awning again. Otherwise there is a risk of lasting damages for
which no guarantee can be made. This thermal protection function acts to ensure the long life of
the awning
● In the event of faults to the electrical drive, retract the awning using the hand crank.
● For perfect operation of the awning, we recommend you lubricate or oil the hinged elements
between the hinged arms at regular intervals.
● After multiple uses of the awning, one or both of the hinged arms may hang at the wrong angle or
unevenly. If this happens, the hinged arms must be readjusted.
2
2

CLEANING AND MAINTENANCE

EN
20
KEN002VKM
v1a • 17.04.2020