Proper Use; Safety Regulations - Hercules H-A 1100 Mode D'emploi D'origine

Anleitung_H_A_1100_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions with
due care. Keep this manual in a safe place, so that
the information is available at all times. If you give
the equipment to any other person, hand over these
operating instructions as well. We cannot accept any
liability for damage or accidents which arise due to a
failure to follow these instructions and the safety
instructions.

1. Safety regulations

The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
2. Layout (Fig. 1-2)
1. Handle
2. ON/OFF switch
3. Head
4. Quick-release clamp
5. Tank
6. Power cable
7. Mains plug
8. Reducer adapter
9. Hose fastener
10. Extraction hose
11. Additional paper filter
12. Pleated filter
3. Items supplied (Fig. 1-2)
Take all parts out of the packaging and check that
they are complete.
Vacuum extraction systems
4 x Reducer adapters (8)
2 x Hose fasteners (9)
Suction hose (10)
5 x Additional paper filters (11)
Pleated filter (12)
Operating Instructions
22.06.2009 16:00 Uhr Seite 9

4. Proper use

The vacuum extraction system is designed for
extracting chippings and dust arising from the
processing of wood or wood-type materials.
The machine must only be used for its intended
purpose!
Any other use is deemed to be a case of misuse.
The user/operator and not the manufacturer will be
held liable for damage and/or injuries of any kind that
result from such misuse.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
To use the machine properly you must also observe
the safety regulations, the assembly instructions and
the operating instructions to be found in this manual.
All persons who use and service the machine have
to be acquainted with this manual and must be
informed about the machine's potential hazards.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
occupational health and safety.
The manufacturer shall not be liable for any changes
made to the machine nor for any damage resulting
from such changes.
Even when the machine is used as prescribed it is
still impossible to eliminate certain residual risk
factors.
The following hazards may arise in connection with
the machine's design and construction:
Hazard due to machine defects:
If one or more parts of the machine are
defective, the use of the machine is prohibited.
Defective parts must be replaced immediately.
Only replacement parts which have been
approved by the manufacturer may be used. It is
prohibited to make any changes to the machine.
Hazard due to electric shock:
Only operate the machine at a power source
which is protected by a residual-current circuit
breaker with a residual current of 30 mA!
Socket-outlets must be properly installed,
earthed and tested!
Risk from starting the machine without super-
vision.
The mains plug must be pulled when the tank is
emptied and if the machine is not in use.
Risk from wood dust
The inhalation of wood dust is harmful. Always
GB
9