Digital Led Voltmeter (Battery Status); 100Ah Gel/Agm Hybrid Battery - Wagan Tech SOLAR e POWER CUBE 1500 PLUS Guide D'utilisation

Digital LED Voltmeter (Battery Status)

The Digital LED Voltmeter provides the user with the current charge state of the internal battery. It
is the user's responsibility to periodically monitor the battery charge and to recharge the battery
after each use. Recharge every three months even if the Solar e Power Cube is not used.
NOTE: Battery status (voltage) is accurate with Charging Adapters disconnected
1. Press and hold the Battery Status Push-Button for 3 seconds.
2. The Digital LED Voltmeter (Battery Status meter) will display the battery voltage.
= 13.5V DC
≥ 12.6V DC
≤ 12.0V DC
< 10.5V DC

100Ah Gel/AGM Hybrid Battery

The Solar e Power Cube is equipped with the latest in battery technology. Supplied batteries
combine the charging characteristics and compatibility of AGM valve regulated, sealed lead-
acid batteries with the improved performance of gel batteries in low discharge rate and high
ambient temperature applications.
These batteries are electrically compatible with AGM batteries for expansion and also follow
AGM charge characteristics. The gel component in them improves performance in low discharge
applications. It is recommended that only AGM batteries be used for long term expansion or
replacement because they are more compatible with portable applications and do not spill or
leak.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation
User's Manual—Read before using this equipment
Storage Hatch
Battery is fully charged
Battery is ready for use
Battery needs some charging
Battery is discharged, charge immediately
© 2013 Wagan Corporation. All Rights Reserved
8