Filling The Clean Water Tank; Fill Level Indicator; Water Flow Adjustment - Numatic TTB 1840 Notice Originale

Filling the Clean Water Tank

The TTB 1840 is equipped with a large 18 litre clean-water tank allowing large areas to be cleaned in a single fill.
1
To fill the clean-water tank, remove the filler cap (Fig.1). Fill using a hose or a suitable container (Fig.2).
Use the fill indicator (Fig.3).
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean
water tank during the filling process. If using a suitable container, ensure it is always clean and free from debris.

Fill Level Indicator

A
Showing the clean-water tank empty

Water Flow Adjustment

1
Located on the left of the machine is the On / Off water tap (Fig.1).
Set the tap to enable the cleaning solution
2
(Fig.A)
.(Fig.2).
Machine Set-up Guide
Fill Indicator
3
B
Showing the clean-water tank full
(Fig.B)
2
11
T 01460 68600