Troubleshooting - Belkin F8T030 Manuel De L'utilisateur

abc-3 4:24:2003 0:53
I can connect to the AP but I cannot connect to external web pages.
Verify the following:
1. The Ethernet cable is properly connected to the AP unit. The LAN LED of the AP
should be on. If it is not on, then the device is not properly connected to the hub.
Please get a proper cable and plug it into a hub port.
2. Connect to the AP home page (http://1.2.3.4) and go to the status page where you
should see the following information:
a) IP address
b) Default Router/Gateway
c) DNS server
All these need to be something other than 0.0.0.0. Otherwise, you need to set these
either manually or using DHCP.
3. Check how fast the system LED is blinking. If it is blinking rapidly (three times per
second), then the AP unit has not acquired its IP address.
50
Page 50
T R O U B L E S H O O T I N G