Important Safety Instructions - RAM 08-355-295 Instructions D'utilisation

Please read these instructions carefully
GB

IMPORTANT SAFETY INSTRUCTIONS

· When using electrical appliances, basic safety precautions should always
be followed including the following:
· Please read all instructions before using this fan.
· Use only for intended purpose, as oscillating wall fan for household use.
· Install fan only in strict adherence to these instruction, failure to do so
might create a safety hazard or result in property damage.
· Do not place fan by open window, immerse fan, plug or cord into water
or spray with liquids.
· Do not hang other objects from the fan.
· Unplug from outlet when not in use, particularly if cleaning, moving or
otherwise maintaining fan.
· Do not place fan or any parts near an open flame,
cooking or other heating appliances.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRICAL SHOCK,
DO NOT USE THIS FAN WITH ANY SOLID STATE FAN SPEED CONTROL DEVICE.
Assembly
Front grill hook
Front grill
Screw hole
1) Remove all parts from the carton:
· Motor Assembly (with grill nut, blade knob and control panel).
· Grill set (front and rear) and fan blade.
2) Assemble the fan head:
· Remove the grill nut and blade knob from the motor assembly. Note the blade knob is reverse
threaded and should be turned clockwise to remove from the motor shaft.
· Place the motor assembly on a flat surface with the shaft facing up. Place the rear grill over the
motor shaft and on to the motor assembly, the rear grill handle should be positioned toward the
top of the fan and the two holes in the rear grill should be aligned with the two small plastic pins
on the motor assembly. Thread and tighten the grill nut on to the motor housing, securing the
rear grill to the motor assembly.
· Mount the fan blade on to the motor shaft by aligning the D shaped hole in the fan blade with
the D shaped motor shaft. Insert the fan blade as far as possible on to the motor shaft and secure
with the blade knob turning the blade knob counter-clockwise. Do not over tighten.
· Mount the front grill cover on to the rear grill cover by fully opening the clips around the outer
edge of the front grill. Align the top center non-opening hook of the front grill with the top
center of the rear grill aligning the 2 holes. Hold the front grill against the rear grill and push the
open clips on the front grill inward until the front grill is secure against the rear grill.
To complete this assembly screw the 2 halves together using the screw and nut provided.
· The fan head assembly is now complete.
Fan blade
Blade knob
Rear grill
Front grill
clip (4)
Grill nut
· Do not operate with a damaged cord or plug or after the fan
malfunctions, or has been dropped or damaged in
any manner.
· The use of attachments not recommended by the manufacturer may
cause hazards.
· Do not operate without fan grill properly in place.
Avoid contact with moving parts.
· This product is intended for household use only and
not for commercial or industrial use.
· If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or a similarly qualified person to avoid a hazard.
Handle
Motor shaft
Screws
Push clip to assemble grill
Motor assembly
Control panel
Hang front grill hook over
top of rear grill