König Electronic EL-WDB301 Mode D'emploi page 2

Wireless doorbell
1. High quality loudspeaker.
2. Mounting hole.
3. Ring option switch: ring only, or LED flash only, or combination of ring and flash.
4. Battery compartment.
5. Volume switch.
6. Tune selection switch.
7. Hold the code-matching button on the receiver and push the button on the receiver at the same
time. Release the code-matching button as soon as the bell rings. Then release the button of the
transmitter accordingly. With this, the code-matching of the doorbell set is finished.
8. Insert the fastening tab of the top cover into the slot of the base.
9. Press here by hand to fix the top cover onto the base.
10. Use a small screwdriver and carefully open this cover on the base unit.
Insert a battery into the battery compartment in the correct polarity.
11. Use the double-sided tape to attach the unit to the desired place.
ENGLISH
2