Mounting; Setting Into Operation; Operation - Leuchtkraft RGBL-412DMX Mode D'emploi

➂
2
DMX IN DMX OUT
6 7
•
Do not place any vessels filled with liquid, e . g .
drinking glasses, on the unit .
•
Do not operate the unit or immediately discon-
nect the mains plug from the mains socket
1 . if the unit or the mains cable is visibly dam-
aged,
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug .
•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not safely mounted, not correctly connected or
operated, or if it is not repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .

4 Mounting

Always place the unit so that sufficient air ventila-
tion is ensured during operation . Never cover the
air vents of the housing .
WARNING The light effect panel must be
mounted in a safe and expert way . If
it is installed at a place where people
may walk or sit under it, it must addi-
tionally be secured [e . g . by a safety rope; lead the
safety rope through the safety lug (3) and fix it so
that the maximum falling distance of the unit will
not exceed 20 cm] .
1
3
MENU/ESC DOWN
8
MIC
UP ENTER
9 10
If a surface is illuminated, the distance to the sur-
face should be 50 cm as a minimum .
1 . The light effect panel can be screwed to a
suitable place via its mounting support (5),
e . g . with a stable mounting screw or a support
for lighting units (C hook) to a crossbar .
2 . As an alternative, the unit can also be mounted
to a wall or ceiling via the two mounting brack-
ets (2) or be set up on the floor . Fix the brackets
with a knurled screw (1) on the left and on the
right of the unit .
To align the unit, release the two locking screws
(1 or 4) . Adjust the desired inclination of the unit
and retighten the screws .

5 Setting into Operation

WARNING To prevent damage to your eyes,
Connect the supplied mains cable to the mains jack
(12) first and then to a socket (230 V/ 50 Hz) . Thus,
the unit is switched on . The display (9) will show
the most recent adjustment (page 2, fig . 1) for a
few seconds before it is extinguished .
Note: The unit provides an overhead control . Thus, it
is switched off in case of excessive temperatures and
switched on again automatically after cooling down .

6 Operation

The operating mode and the different functions are
selected via a menu (page 2, fig . 1) with the but-
tons MENU / ESC, UP, DOWN and ENTER (8) . For op-
eration via a DMX light controller, see chapter 6 .6 .
MIN MAX
SENSITIVITY
11 12
never look into the light source for
any length of time .
Please note that fast changes in
lighting may trigger epileptic sei-
zures with photosensitive persons
or persons with epilepsy!
230 V~ / 50 Hz
13
11