YAMIT AF900 Série Manuel D'utilisation Et De Maintenance page 37

AF900
1. SYSTEM INTO SCREEN
Screen 0-MENU
OK
Screen 0.0-STATUS
Screen 0.1
TOTAL FLUSH CYCLE
Screen 0.2
INT. FLUSH CYCLE
Screen 0.3
MAN FLUSH CYCLE
Screen 0.4
REMOTE FLUSH CYCLE
Screen 0.5
DP FLUSH CYCLE
System status screen 0.0 :
FILTERING – The system is in filtering state.
DP FLUSH – The system is in flush cycle caused by DP signal.
MANUAL FLUSH – The system is in flush cycle caused by manual sw.
INTERVAL FLUSH – The system is in flush cycle caused by interval
timer.
REMOTE FLUSH – The system is in flush cycle caused by remote
signal.
SYSTEM DISABLED – The system is disabled via the ENA inlet.
YSTEM DISABLED – The system is disabled via the ENA inlet.
TOTAL FL CYC screen 0.1 :
ESC
This screen shows the current total flush cycles.
Note that the total value can be reset to 0 count by the user.
The flush cycle counter is reset to 0 automatically when reaching
32000 counts.
UPDATE
VALUE
ESC
Use to clear the counter
(Range 1 – 32000 cycles)
ESC
ESC
ESC
ESC
ESC
TOTAL FL CYC screen 0.1 :
This screen shows the current total flush cycles.
LAST DP FL screen 0.7 :
This screen shows the elapsed time (In minutes) since the last DP
ESC
flush cycle only.
Note that the time counter is reset on power up or when reaching
32000 min.
OK
Screen 0.6
LAST FLUSH CYCLE
Screen 0.7
LAST DP FLUSH
37