Working Advice - Bosch Aquatak Go Notice Originale

OBJ_BUCH-683-001.book Page 20 Thursday, February 7, 2008 4:29 PM
20 | English
Operation
Starting and Stopping
Starting
Connect the product to the mains supply ensur-
ing that the mains switch is in the off position.
Open water tap.
Press the safety lock 4 to release the trigger 3.
Fully press the trigger 3 until there is a constant
flow of water to clear the air from the machine
and water supply hose. Release trigger 3. Press
the trigger safety lock 4.
Press button „I" on main switch 5.
Point the power gun 2 downwards. Press the
trigger safety lock 4 to release the trigger 3. Ful-
ly press the trigger 3.
Autostop function
The machine is designed to switch off the motor
when the trigger 3 is released on the gun. This
feature relieves high pressure from the system
to achieve a longer lifetime and lower energy
consumption.
Stopping
Release trigger 3. Press the trigger safety lock.
The power gun is now locked and can not be op-
erated accidentally.
Press button „O" on the main switch 5.
Close water tap. Unplug the machine from the
electric supply.
Press the trigger safety lock 4 to release the trig-
ger 3. Fully press the trigger 3 until there is no
more water pressure in the machine. Release
trigger 3. Press the trigger safety lock 4.
Disconnect water supply hose from machine
and water supply.
Self priming function
The machine is designed to also operate with
water from sources other than a water tap, e . g.
ponds and water butts due to the self priming
function. The use of an additional water filter
(not supplied) is recommended for this kind of
use.
F016 L70 529 | (7.2.08)
Make sure that water source is situated no more
than 1 meter below the level of the machine.
Fill water supply hose (not supplied) with water
K
before connecting it to the machine.
Run machine without lance attached until there
is a constant flow of water.
Turn off machine and connect lance.

Working Advice

General
Ensure that the machine is on level ground.
Do not kink or drive a motor vehicle over the
high pressure hose. Do not expose the high
pressure hose to sharp edges or corners.
Never use the roto nozzle to clean motor vehi-
cles.
Working advice for cleaning with detergents
Detergents can be applied using the detergent
bottle/foam lance.
Read the detergent label for additional instruc-
tions.
Always wet the object first.
Apply detergent to the object from the bottom
up.
Give the detergent time to work, but never leave
it to dry.
Rinse from top and work downwards.
Bosch Power Tools