Cleaning, Care & Maintenance - Polar Refrigeration CD239 Mode D'emploi

UK
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.
Operation
Control Panel
• Plug the mains lead in to the socket and switch
on, then turn on products using the mains
switch (this will light up).
• When the refrigeration system is operating
the left hand LED will be lit, when it reaches
temperature and turns off the LED will go out.
4
CD239_ML_A5_v2_171215.indb 4
Digital Temperature Controller
Operation
1. Press SET button. The set temperature is
displayed.
2. Press or button to modify and store the
displayed value.
3. Press SET button to exit the adjustment and
within 10 seconds, the Multideck temperature
will be displayed.
Lighting
To turn on the display light press
off press again.
Manual Defrost
Press button and hold for 6 seconds to start or
stop the defrost process.
Cleaning, Care &
Maintenance
1. Before cleaning always disconnect the
Multideck Refrigerator from the electricity
supply.
2. Clean using either warm soapy water, or a
suitable antibacterial cleaning agent, dry
thoroughly before reconnecting the electricity
supply.
3. Do not use abrasive or corrosive cleaning
agents.
Cleaning the Condenser
Your Polar Multideck Refrigerator will benefit from
having the condenser cleaned at regular intervals,
your Polar service agent will be able to carry this
out for you.
button. To turn
2017/12/15 13:40