P6701B And P6703B Specifications; Warranted Characteristics - Tektronix P6701B Mode D'emploi

P6701B and P6703B Specifications

The specifications in Tables 4 through 6 apply to a P6701B or
P6703B O/E converter. The converter must have a warm-up period
of at least 20 minutes and be in an environment that does not exceed
the limits described in Table 4.
Specifications for the P6701B and P6703B O/E converters fall into
three categories: warranted, typical, and nominal characteristics.

Warranted Characteristics

Warranted characteristics (Table 4) describe guaranteed performance
within tolerance limits or certain type-tested requirements.
Warranted characteristics that have checks in the Performance
Verification section of the service manual (070-9892-XX) are
marked with the
Table 4: P6701B and P6703B warranted electrical characteristics
DC optical input dynamic range
Absolute maximum non-destructive
optical input
DC conversion gain
AC conversion gain
Output zero
20
symbol.
DC electrical out will meet conversion gain
specifications up to 1 mW (0 dBm) peak
optical power input
10 mW average power; 20 mW peak power
P6701B: 1 V/mW 8% at DC, 780 nm
P6703B: 1 V/mW 8% at DC, 1310 nm
P6701B: 1 V/mW 8%, with 100 W
optical modulation, 780 nm
P6703B: 1 V/mW 8%, with 100 W
optical modulation, 1310 nm
1 mV into 50 , 20 to 25 C
P6701B, P6703B & P6723 Instructions
P-P
P-P