Jennair JVR0430HS Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

Charcoal Filter Bracket Installation
1.
Align charcoal filter bracket
Remove the charcoal filter bracket from the box and place
■
it at the desired height above the hood canopy bottom (use
provided template for reference).
Ensure the center of the bracket is aligned with the center
■
line marked to confirm the center of the hood aligns with the
center of the filter bracket.
2.
Drill pilot holes
Mark holes as per center line and drill 2-5/16" (8 mm) holes.
■
Tip: Use a level tool to ensure the bracket is level before
drilling the holes.
3.
Install 2 anchors and screw the bracket into place.
■
Do not fully tighten the screws as the bracket will need to be
■
removed in the next step.
4.
2 5/16" (8 mm)
Mark the center hole with a pencil.
■
Install anchors
Mark center hole
9