5.
Remove bracket
Remove the screws (not the anchors) in order to remove the
■
bracket.
6.
Drill center hole
1
Drill a 5/16" (8 mm) hole where the center hole is marked and
■
insert 1-5/16" (8 mm) anchor.
7.
Mount charcoal filter bracket
Place the charcoal filter bracket back into position so that all
■
the holes are aligned with the anchors.
Secure 2 screws on the upper bracket slots and one screw
■
with a flat washer on the lower bracket slot, to secure the
bracket in position.
10
5/16" (8 mm)
3
Prepare for Installation
1.
Verify electrical outlet location
120 V, 60 Hz
Ensure grounded 3 prong outlet capable of 120 V, 60 Hz is
■
available before proceeding.
Ensure at least 3/8" (1 cm) gap between bottom of the
■
charcoal filter bracket to top of the grounded 3 prong outlet.
Ensure at least 1
/
" (3 cm) gap between anchor screw and
3
■
16
the bottom of the grounded 3 prong outlet.
Ground 3 prong outlet must be 13/16" (2 cm) shorter in width
■
than the chimney width.
2.
Remove grease filter
Remove grease filters before proceeding.
■
3/8" (1 cm)
13/16" (2 cm)
1
/
" (3 cm)
3
16