nilco SE 1400 Manuel D'utilisation Et De Maintenance page 7

The injection-extraction machines mod. SE 1400 and SE 3000, designed to clean carpet and hard floor,
are formed by the body, the hoses and the wand.
The body is composed by two high-density polyethylene tanks, kept together through lateral elastic hooks.
The upper tank (recovery tank) is foreseen to contain the dirty water sucked from the carpet or floor. The
lower tank (solution tank) is foreseen to contain the water and the chemical detergent. The lower tank also
contains the motor group, the pump and the control panel. In the model SE 1400 the control panel is
located on the upper tank.
Every electrical device must be used for its particular function only, respecting the manufacturer's
instructions. Failure to adhere to the instructions could result in serious person injury, electric shock, fire or
explosion.
The nowadays machines are normally produced according to the accident prevention regulations and are
often homologated by qualified institutes for the safety, but nobody and nothing can save irresponsible
users from danger.
Please, read carefully the following points and be sure to understand everything before using the
machines. The following information signals potentially dangerous conditions to the operator or
equipment.
WARNING: Fire or Explosion Hazard.

Do not spray water near electrical outlets.

Do not use the machine to spray or to suck dust, corrosive liquids (acids or bases) and explosive or
inflammable liquids.

Do not use the machine in an explosive atmosphere. This machine is not equipped with an explosion
proof motor. The electric motor will spark when powered on which could cause a flash fire or explosion
if machine is used in an area where flammable vapors/liquids or combustible dusts are present.

Never use flammable liquids or operate machine in or near flammable liquids, vapors or combustible
dusts.
WARNING: Electrical Hazard.

Before putting the machine's plug in the current socket, check that the voltage available is the same
indicated on the label of the machines.

Be sure that the electrical system is well earthed and that it has a safety differential switch.

Verify that the cable plug is complying with the outlet.

Do not modify plug.

Do not use adapters or multiple sockets, without knowing the electrical input of each user.
Generalities
Safety instructions (read carefully)
7