12 Care And Cleaning; Condenser Cleaning; Internal Cleaning - Fhiaba 1T Mode D'emploi

Masquer les pouces Voir aussi pour 1T:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Scrupulously follow the detailed directions that
can be found in the provided kit and never
use abrasive or metallic products which could
appliance permanently.
Before performing any sort of cleaning, disconnect
the appliance from the electrical power supply.
Make sure you do not damage the refrigerant
circuit in any way.
The edges of the condenser are sharp, there-
fore use adequate protection for the hands and
arms when cleaning the condenser.
Do not use water on the electrical parts, lights
and control panel.
Do not bring cold glass parts into contact with
boiling water.
Do not wash any parts of the refrigerator in a
dishwashing machine since this could damage
or irreparably deform the parts.
To clean the parts in steel use a microfiber cloth and the sponge pro -
vided in the kit with the appliance.
Every now and then, to make to steel shiny, wipe with a slightly damp
Do not use the sponge on aluminium parts, such as the handles and the
You should use special care to keep free of obstructions the ventilation
openings in the appliance or in the cabinet that houses it.
A ventilation grille is located either at the top of the appliance or at the
bottom according to the model type.
To clean it use a vacuum cleaner with a soft brush attachment at maxi-
build up, the ventilation grille can be removed to allow a more accurate
Every 6 months the display shows the message "Check Cond", clean the
condenser and press for 5 seconds the Enter
Operate as follows:
Switch off the appliance by pressing the Unit button
control panel for approx 3 seconds.
temperature.
On models with ventilation at the base remove the grille at the bottom
(magnetically attached) and take it off. On models with ventilation lift the
grille as shown in the picture.
cleaner and the soft brush attachment.
Clean it thoroughly from any dust build up as shown in the picture, tak-
ing care not to damage it.
Start up the appliance again, by pressing the Unit button
Clean the internal and removable parts by washing them with a solution of lukewarm water, a small
amount of dishwashing detergent.
Rinse and dry right away.
Do not use mechanical devices or other methods to speed up defrosting.
Care and Cleaning
Care and Cleaning

Condenser cleaning

button to reset.
on the main
on the main

Internal cleaning

12
12.1
12.2
12.3
25

Publicité

Chapitres

Table des Matières
loading

Table des Matières