Cleaning And Maintenance; Technical Specifications - Livington INSTANT WATER HEATER Mode D'emploi

3. Make sure that the seal ring with the crown upwards is in the fitting for the intake and screw this
together with the water heater (Illustration 2).
4. Slide the supplied rubber washer onto the connector for the inlet and fix the water heater on your
sink (Illustration 2). To fix the water heater with the washbasin, screw from the bottom of the
washbasin the supplied securing nut onto the fitting for the intake.
5. Now attach the water pipe to the connector for the intake (Illustration 2).
6. Open the water supply and press the lever from the water heater down (Illustration 3). Turn the tap
gently to the left and right. Make sure that the connection is tight or fix any leaks before use.
7. Connect the plug from the water heater to the electric circuit.
NOTE: First, connect the water. If there are no leaks, the device can be connected to the power!
8. Once you set the lever to warm water, a red light comes on and the water temperature climbs
steadily. The red light goes off when the hot water is turned off again.
WATER TEMPERATURE ADJUSTMENT:
Depending on the position of the lever you can choose between cold, warm and stop positions
(Illustration 3). When the lever is pushed upward, the flow of cold water can be increased, pushing
the lever down increases the flow of hot water. With the increase of the flow rate, the water temperature
may at first decrease then after a few seconds the desired hot water will flow from the tap.
Note: In the water heater is an automatic switch, which is why a plugging and unplugging of the
device is unnecessary.

CLEANING AND MAINTENANCE

Even if the water heater is used irregularly or rarely, it must be cleaned. Unscrew and remove the cap
from the tap counter-clockwise and remove the strainer. Remove possible deposits by holding the sieve
under a water jet or scrape with a thin iron wire. Afterwards secure the attachment including the sieve
back onto the tap.
Water filter: If the water pressure decreases after time, a filter might be out of position. Before you
begin cleaning, pull the plug from the socket, so that the water heater is not connected to the circuit
and turn the water supply off. Unscrew the water heater from the fitting for the intake. Use a small
screwdriver to remove the fixing ring. Turn the water heater around and the filter and magnet ring will
fall out (Illustration 4). Scrape possible deposits from the filter and then insert the magnetic ring, filter
and mounting ring again.
TROUBLESHOOTING
• The red light is not lit and there is no hot water from the tap when the lever is on "hot"?
Make sure that the device is connected to the circuit and the water supply pressure is not less than
0.04 MPa.
• The red light is on but the water is not hot?
A: The water pressure was became too high too quickly, wait a few seconds or decrease the water
pressure.
B: The heating component is damaged, contact the manufacturer.
• The water's hot but the water pressure is low?
Check sieve, filters and other water outlets for deposits and clean them. If after cleaning the water
pressure is low, it is because of insufficient water pressure coming from the supply.

TECHNICAL SPECIFICATIONS:

Power (kw): 3
Power source inside wire diameter (mm) ≥ 1,5
Air switch (A): 16
Ammeter (A): ≥ 20
Water pressure (Mpa): 0,04 – 0,6
220 – 240V
9