Datalogic STAR Modem Guide Rapide page 17

DATALOGIC
For changing the configuration parameters when using the Digital
Terminal interface, send the new values via radio through Datalogic
RF devices. Otherwise, send the $+CP0$-CR string via radio to set
the RS232 interface and define the parameters via serial interface.
This operation sets the RS232 parameters to default values and
erases the current header and terminator selection. Thus, after
configuration setting, you must restore the Digital Terminal interface,
CAUTION
Header and Terminator selection by sending a command string
similar to the one given in the following example:
$+CP512EA0141EA1102$-CR.
If you selected the Wedge interface, you should also send among the following
strings the one the matches your Keyboard Nationality:
English
Deutsch
Svenskt
Français
Italiano
USA
Español
Belge
STAR Modem Transmitter (Client)
RESTORE DEFAULT
Whenever necessary, send the following string to STAR Modem™ via RS232 to
restore its default values:
Restore STAR Modem™ Default
This command does not change the STAR Modem™ address nor the address of
the Stand Alone destination device, nor the RF Baud Rate parameters.
UK/US
$+FJ4$-CR
$+FJ3$-CR
$+FJ5$-CR
$+FJ2$-CR
$+FJ1$-CR
$+FJ0$-CR
$+FJ6$-CR
$+FJ7$-CR
$+$*CR
9