Wiring Information (Pour Le Royaume-Uni Uniquement) - Brother HL-2400Ce Série Guide De L'utilisateur

Table des Matières

Publicité

Wiring Information (Pour le Royaume-Uni uniquement)

If the mains plug supplied with this printer is not suitable for your socket outlet,
remove the plug from the mains cord and fit an appropriate three pin plug. If the
replacement plug is intended to take a fuse then fit the same rating fuse as the
original.
If a moulded plug is severed from the mains cord then it should be destroyed
because a plug with cut wires is dangerous if engaged in a live socket outlet. Do
not leave it where a child might find it!
In the event of replacing the plug fuse, fit a fuse approved by ASTA to BS1362
with the same rating as the original fuse.
Always replace the fuse cover. Never use a plug with the cover omitted.
WARNING - THIS PRINTER MUST BE EARTHED
The wires in the mains cord are coloured in accordance with the following code
:
Green and yellow:
Blue:
Brown:
The colours of the wires in the mains lead of this printer may not correspond
with the coloured markings identifying the terminals in your plug.
If you need to fit a different plug, proceed as follows.
Remove a length of the cord outer sheath, taking care not to damage the
coloured insulation of the wires inside.
Cut each of the three wires to the appropriate length. If the construction of the
plug permits, leave the green and yellow wire longer than the others so that, in
the event that the cord is pulled out of the plug, the green and yellow wire will
be the last to disconnect.
Remove a short section of the coloured insulation to expose the wires.
The wire which is coloured green and yellow must be connected to the terminal
in the plug which is marked with the letter "E" or by the safety earth symbol
or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which is
marked with the letter "N" or coloured black or blue.
The wire which is coloured brown must be connected to the terminal which is
marked with the letter "L" or coloured red or brown.
The outer sheath of the cord must be secured inside the plug. The coloured wires
should not hang out of the plug.
Important
Earth
Neutral
Live
REGLEMENTATIONS
,
xvii

Publicité

Table des Matières
loading

Table des Matières