The Indicator Lights; Clean The Filter; Low Temperature Drying; Delayed Start - essentiel b ESLE8-1b Notice D'utilisation

* Energy label standard programme (EN 61121: 2012)
All the values indicated in this table have been determined in accordance with standard EN
61121: 2012.
Please note that these values may vary slightly depending on the type of laundry, the spin
speed, environmental conditions and voltage variations.

The indicator lights

1) "Clean the filter":

The filter indicator light comes on to remind you to clean the lint filter at the end of the
programme.

2) Low temperature drying:

For certain programmes, for specific fabrics (delicate, synthetic, etc.), the
comes on automatically. This means that the appliance is drying at a low temperature to
protect the laundry.

3) Delayed start:

You can delay the start of a programme by 3, 6 or 9 hours.
Select a programme using the programme selection knob.
1.
button once to select a delayed start of 3 hours (the "3"
Press the
2.
indicator light comes on). Press the
of 6 hours (the "6" indicator light comes on). Press the same button a third
time to select a delayed start of 9 hours (the "9" indicator light comes on).
If you press the button a fourth time, all delayed start programmes will
3.
be cancelled.
Press the button to save the delay start. The countdown begins.
4.
You can add or remove laundry during the countdown. At the end of the
•
countdown, the indicator light turns off and drying begins.
To modify a delayed start:
−
Cancel the programme by turning the programme selection knob to the "Stop" position
1.
Select the same programme again and repeat the delayed start activation steps (see above).
2.
To cancel the delayed start and start the programme immediately:
−
Cancel the programme by turning the programme selection knob to the "Stop" position
1.
Select the same programme again and press the
2.
indicator light comes on indicating that the programme has started.
58
V.1.0
laundry preparation
indicator light
button again to select a delayed start
button to start it. The "drying"

4) Programme progress:

A programme's progress is displayed on the programme monitoring indicator. Each time new
drying stage begins, the corresponding indicator light comes on and the previous stage's
light turns off.

Modify a running programme

You can change the selected drying programme and choose a new programme even if the
dryer is operating.
For example:
Select the "Extra dry" programme by turning the programme selection knob to the "Extra
1.
dry" position instead of "Ready-to-iron".
Press the button to start the new programme.
2.

Adding/removing laundry

To add or remove laundry after a programme has started:
Press the button to "pause" the appliance. This will interrupt the drying process.
1.
Open the door, add or remove laundry, then close the door.
2.
Press the button to restart the programme.
3.
.
N
ote : Laundry added during the drying process may cause the laundry already dried in the
machine to mix with wet laundry. As a result, the laundry will still be wet at the end of the
drying process.
.
2-hour wrinkle guard
End of programme
"Ready-to-wear" drying level
"Ready-to-iron" drying level
Drying in progress
V.1.0
laundry preparation
59