Tasseron Elmeco Mode D'emploi page 27

MAINTENANCE
STORAGE
The electronics of the pH meter are very sensitive and
therefore it is necessary to store the meter in a dry place at
room temperature in order to prevent condensation in the
meter.
TO CLEAN
A pH probe may be contaminated by organic or even fatty
deposits. This is evident from a slower approach to the final
value or when it is no longer possible to calibrate the meter.
The probe is best cleaned with ammonia. First try to clean it
by stirring vigorously and only wipe the glass bulb and the
ceramic ring a soft cloth in extreme cases. Place in the
PROBECARE for some time again.
BATTERY
If the battery is running low, then the meter will display an
arrow-shaped symbol or the message "LO BATT" in the top
left-hand corner of the display.
Replace the batteries.
SPECIFICATIONS
Range
Deviation after Calibration
Temperature range
Dimensions
Battery
0 - 14 pH
± 0,01 pH
0
0 - 80 C
45 x 90 x 155 mm
DURACELL ALKALINE
27