Maintenance And Service - Enerpac BHP-152 Notice D'emploi

5.6 Using bearing puller attachment
The bearing puller attachment can be used in
combination with the crosshead puller shown in the
illustration 4 below and illustration 6 on page 8.
illustration 4 - Bearing puller attachment with
Crosshead Puller
Do not
exceed
50% of
rated
capacity.

6.0 MAINTENANCE AND SERVICE

Maintenance is required when wear or leakage is
noticed. Periodically inspect all components to detect
any problem requiring service and maintenance.
Enerpac offers ready-to-use spare parts kits for
repair and/or replacements. Contact Enerpac.
IMPORTANT:
must be serviced by a qualified hydraulic
technician. For repair service, contact
the Authorized Enerpac Service Center in
your area.
• Periodically inspect all components to detect
any problem requiring maintenance and service.
Replace damaged parts immediately.
• Do not exceed oil temperature of 60˚C [140˚F].
• Keep all hydraulic components clean.
• Keep your pulling equipment in shape. Clean and
lubricate the puller's adjusting screw and puller
legs frequently, from thread to tip, to ensure good
operation and long life.
• Periodically check the hydraulic system for loose
connections and leaks.
• Change hydraulic oil in your system as recom-
mended in the pump instruction sheet.
Hydraulic equipment
4