Electrical Wirings - Olimpia splendid B0152 Mode D'emploi

ELECTRICAL WIRINGS

Carry out the wirings according to the electrical diagram shown in this manual (fig.10).
INSTALLING THE MINIMUM/MAXIMUM PROBE
To use the minimum/maximum temperature detection probe of the system fluid with the wall-
mounted control, proceed as follows:
- Identify the water temperature probe already assembled on the fan coil unit.
- Connect the probe to the regulator as indicated in the diagram (fig. 10), using the bipolar cable with
double insulation and maximum overall length equal to 10 m. This connection must be maintained
separated from the power supply cables and any other power cables available. The junction between
probe and connection cable must be maintained suitably protected and not accessible from outside the
fan coil. Do not connect or disconnect the probe with the powered regulator.
ATTENTION!
THE DEVICE MUST BE INSTALLED BY QUALIFIED PERSONNEL IN COMPLIANCE WITH THE
SAFETY STANDARDS AND LAWS IN FORCE.
CUT THE POWER BEFORE MAKING OR INTERVENE ON ANY ELECTRICAL CONNECTION.
THE MANUFACTURER IS NOT LIABLE FOR ANY IMPROPER USE OF THE PRODUCT.