Beta 3027/PR Notice D'utilisation Et Instructions page 6

OPERATION MANUAL AND INSTRUCTIONS
UNIVERSAL SUPPORTING TOOL FOR THE REMOVAL AND INSERTION OF BEARINGS
Original documentation drawn up in ITALIAN.
CAUTION
INTRODUCTION
- You are required to read this instruction manual before carrying out any operation.
- Both the guarantee of the proper operation of this product as well as the full compliance of its performance highly depend
on the application of all the instructions contained herein.
- We hereby ensure that this product complies with the technical specifications described in this manual.
- Any misuses, other than those described herein, are not the responsibility of the manufacturer.
Use protective work gloves, safety footwear, hard hat and goggles.
Misuse:
- This product should only be used as described in this documentation; any other use is considered improper.
- The manufacturer accepts no responsibility for any damage caused by the incorrect or unreasonable use of
the equipment;
- Moreover, misuse shall also void the warranty.
Take care of your tools:
- Be sure to store your tools in a clean state.
- Place the tools inside their original package.
Universal system which allows the assembly and disassembly of hubs/bearings and silentblocks by operating
under a press.
The tool set is made up of a supporting base and its accessories which allow the user to mount/dismount bearings
into/from their housing (fig. 1) by means of a press system.
This tool's universal feature consists in being able to adapt to the irregular geometric shapes of hubs/king pins on which the
operator must often intervene.
The tool set comes with several components (fig. 2), the most important being the following:
- 1 supporting plate (ref.1)
- 3 spacer units consisting of a high column and a slotted base (ref. 2,3)
- 1 low column (ref. 4)
- 3 threaded screws (ref. 5,6)
- 1 centering disc (ref. 7)
- 4 safety screws (ref. 8)
6
READ THIS OPERATION AND MAINTENANCE INSTRUCTION MANUAL
BEFORE STARTING ANY OPERATION.
BETA 3027/PR