General Information; Installation Requirements - Thetford C-402 Manuel D'installation

ENGLISH

GENERAL INFORMATION

The Cassette toilet is available in 2 types:
C-402 Cassette toilet with built-in water tank. The flush is operated by a 12V electric
pump.
C-403 Cassette toilet which takes flush water from the central water tank of the
caravan or motor home. The flush is operated by a 12V electric valve and a
relay.
Important! We advise you to have your Thetford Cassette toilet safely installed at a
classified Service Center. For a Service Center near you, please visit www.thetford -
europe.com.
The Thetford Cassette toilet is a semi portable integrated toilet system for caravans
and motor homes. The unit is available in either right hand or left hand versions,
depending on which side the cassette (waste tank) has to slide in and out as viewed
from the seated position (see indication on packaging). It is recommended that the
toilet is fitted together with a shower pan that has an upturned flange (see diagram
1). The flange fits between the two ribs under the base of the toilet to avoid shower
leakage. The toilet can also be installed without a shower pan.

INSTALLATION REQUIREMENTS

1. Minimum size requirements of bathroom are 670 mm wide (with wall seal add
2 more mm), free floor space depth to back wall 270 mm, free height 820
mm. At the bottom front outer side of the toilet is a removable e xtension front
panel to create free space underneath the toilet of 85 x 70 mm for ducting
(see diagram 1).
2. If bathroom is situated at the rear of the caravan or motor home, the distance
from the cassette door aperture to the rear wall should be a min. 20mm for
fitting of door frame. Outside trim to be taken into consideration. There should
be a similar minimum clearance between the wheel arch (see diagram 3 & 4).
3. There has to be a vertical back wall to fit the toilet against.
Attention! Be sure you have enough room to saw behind the wall to which the toilet
is to be fitted (see diagram 5). Depending on the door type. Check with your caravan
or motor home dealer to avoid damaging vital parts at the door aperture cut out.
4. A wooden frame or 4 aluminum strips of 3 mm should be inserted to the wall
around door aperture for fixing screws (see diagram 6). Glue for rigidity.
5. Thetford advises that the door frame hinges face the driving direction.
6. The C -402 versions have an electric pump, which will draw 3 amp. M ax
(12V). Therefore a 12V DC electric supply must be available either direct
(battery) or indirect via a transformer (5 amp. Min.).
7. The C-403 will be connected to the water system of the vehicle. To operate
the electric valve and relay, a 12V DC electric supply must be available either
direct (battery) or indirect via a transformer. In order to get a good flush the
inlet of the toilet should have the following requirements:
- A minimum pressure of 0.5 bar
- A minimum flow of 6L/per minute.