System Components Fitted To The Gate; Device Overview; Signal Indicators - ASO Safety Solutions INDUS rail 71-242 Mode D'emploi

Inductive signal transmission system

5. System components fitted to the gate

1
10 1 2
3 11 3
2 2 2
Example of use
The actual arrangement of the individual components
depends on the design of the gate in question and the
conditions at the installation site.

6. Device overview

6.1 Signal Indicators

LED Power (green)
Operating state (on)
Error message (pulse output)
LED Transmit Opening (red)
travelling edge(s) for opening movement
actuated / interrupted (on)
LED Stationary Opening (red)
stationary edge(s) for opening movement
actuated (on) - interrupted (flashes)
LED Transmit Closing (red)
travelling edge(s) for closing movement
actuated / interrupted (on)
LED Stationary Closing (red)
stationary edge(s) for closing movement
actuated (on) - interrupted (flashes)
V1.0: If no error is present, then LED Power shows the function control (briefly off).
V4.0 and later: If no error is present, then LED Power shows the operating state (on).
During the output of an error message, the number of output pulses indicates the error:
Pulse Error message
1 Voltage supply outside of the valid value range
2 Inductive signal transmission system error
3 Output control Open faulty
4 Output control Close faulty
5 Data transmission with microcontroller faulty
6 Testing sensor input faulty (stationary safety contact edges) (Open/Close)
16
2
1 INDUS rail 71-242 (INDUS rail 71-942) control device
2 Stationary coil core
3 Travelling coil core
4 Steel cable acting as transmission medium
- with 2 additional wires
3
4
INDUS rail INDUS rail
71-242 71-942