Software Installation - Velleman CAMCOLVC4 Notice D'emploi

7.

Software installation

• Install the software before connecting the camera to a PC. Place
the included mini-CD into a suitable CD-loader. When the
installation doesn't start automatically, locate the setup.exe file on
the CD and double-click it.
• Click 'Next' in the welcome screen.
• Select 'I accept...' in the license agreement screen and click 'Next'.
• Click 'Install' to start software installation.
• In the Wizard completed screen, click 'Finish'. The software is now
ready for use. Note that to use the CAMCOLVC4 as webcam, a
driver is also required (see §8).
8. Use as webcam
• Plug the A-plug of the included USB cable into a free USB port.
• Make sure the power ON/OFF switch [7] is in the ON position.
• Press and hold the shutter button [4] while plugging the mini-B
connector into the mini USB port [6].
• The 'Found new hardware' wizard starts
automatically' and click 'Next'.
♦
If the wizard doesn't start, disconnect the USB cable and verify
that the power ON/OFF switch [7] is in the ON position.
♦
Check in 'Device Manager' – 'Imaging Devices' whether the
camera is listed as 'MR97316 VGA Dual Mode Camera"
• A window pops up notifying the user that the software did not pass
'Windows Logo testing'. This message can be ignored, click on
'Continue Anyway' to continue the installation.
• When installation is complete, click 'Finish'.
• Locate the MR97316MarsPCAM icon on the desktop and double click
it. The application opens:
08/04/2009
CAMCOLVC4
♦
5
. Select 'Install the software
©2008 Velleman Components nv
®