Velleman CAMCOLVC4 Notice D'emploi page 4

4. Features
• use as webcam or PIR sensor picture camera
• record images in JPG format on SD card (256Mb SD card included)
• PIR motion detection
• in PIR detector housing
• easy installation, just plug & play and the camera starts recording
• comes with AC power adaptor, 256Mb SD card, software and
mounting bracket
• system requirements: Windows
5. Overview
The CAMCOLVC4 can be used as a passive IR sensor that captures
images every 3 seconds when motion is within PIR range, or as
webcam.
Refer to the illustrations on page 2 of this manual.
1 DC input
2 status LED
3 SD card slot
4 shutter button
6. Use as PIR sensor picture camera
• Insert the included 256MB SD card (or another one, ≤ 1GB) into the
SD card slot [3], connector pins facing towards back of the camera.
• Make sure the power ON/OFF switch [7] is in the OFF position and
plug the DC connector from the included adaptor into the DC input
[1] from the camera. Plug the adaptor in a mains outlet.
Note: only use the included power adaptor.
• Wait at least 30s for the camera to initialize before switching the
power ON/OFF switch [7] to the ON-position. The camera will take a
picture every 3 seconds when motion is detected within the
detection range (±5m). Note that there is no date or time stamp on
the images. Image size normally <100KB.
• Press on the shutter button [4] to take an instant photo.
• The camera can be mounted on the wall using the included
mounting bracket. Do not point towards bright objects.
• To review the images, see §9.
08/04/2009
CAMCOLVC4
®
XP, Vista
5 pinhole camera
6 mini USB port
7 power ON/OFF switch
8 PIR sensor
4
©2008 Velleman Components nv
®