INTERTECHNO ITH-610 Mode D'emploi page 30

GB
By pressing the OK button, within 30 seconds this can be taught in using the transmit-
ter's ON or OFF signal.
Repeat the process by pressing OK for additional transmitters.
Ful will appear on the display after the fourth teaching-in operation.
Pressing the menu button takes you out of the menu.
The daytime temperature is now selected using the On signal.
You can switch to the night temperature using the Off signal.
You can change the temperature remotely at any time in either Manu or Auto
operation.
Note: Wireless remote control is not possible in holiday mode.
Delete: To delete all codings (transmitters), go to Unl in the menu and confirm using
OK, exit the menu using the Menu button.
Setting the weekly programme:
Press the Menu button until "Pro" appears on the display.
After pressing the OK button, use the dial to select the individual days, whole week or
even MON-FRI/SAT-SUN. Confirm using the OK button.
3 on and off times are available at which a certain temperature can be selected. Select
a start time with the dial and press OK to confirm. Select a finish time with the dial and
press OK to confirm. Select the desired temperature with the dial and press OK. You
will automatically be taken to the next time selection screen, proceed as described
above.
If you only require two on/off times, select the same on/off time twice.
OFF will appear on the display, confirm by pressing OK.
Start the weekly programme by repeatedly pressing the menu button until "Auto"
appears.
The selected times are shown on the display (12/13).
The temperature can be changed at any time in the weekly programme either wire-
lessly or by using the dial.
Holiday mode:
This mode is used to set a desired temperature for when you're away on holiday (e.g.
to avoid frost)
Press the Menu button until
The time will flash. Enter the time (by the hour), date and temperature until you return
using the dial and then press the OK button.
Note: The thermostat cannot be controlled wirelessly when in Holiday mode!
If you would like to switch to the higher selected temperature using your smartphone
before you arrive, we recommend setting a minimum temperature (to avoid frost)
before you leave, so that you can then switch to the higher temperature remotely
using an intertechno Gateway (e.g. MasterGate).
Child lock:
Press the buttons and MENU simultaneously, "LOC" will then be displayed
on the screen.
Press again to deactivate the child safety lock.
Operating instructions
appears on the display.
ITH-610
Menu
Press t
exit th
Use th
Pro W
dAt D
AEr T
toF T
rES
rFS T
UnL D
tEP
InS A
G
T
t
T
T
I
b
R
D