Carat DPZ230NK00 Manuel D'utilisation page 11

3. Set the position of the Hinge
Pin on the center line of the
angle grinder.
(Fig.4 and 5)
4. Confirm the Hooks securely
stored into the groove at the
Gear Case.
(Fig.6 and 7)
O K
INSTALLATION
1. Hold [c] Adaptor with the down-force.
2. Tighten [n] / [o] Bolt by [p] Hex Wrench
to clamp the gear case.
[n] Bolt (L60) : for BOSCH
[o] Bolt (L45) : for Others
* Make the [n] [o] Bolt head facing the
Flat Surface of [c] Adaptor.
(Fig.8)
3. Push the Lever.
4. Open the Lower Base.
5. Place [a] Main Unit on [c] Adaptor.
6. Screw [d] Centering Holder into the
spindle of the angle grinder to fix [a] Main
Unit and [c] Adaptor temporary.
7. Match the position of the Hole at [a]
Main Unit and the Screw hole at Hinge
Pin of [c] Adaptor.
(Fig.9)
O K
Hinge Pin
[c]
Groove
Hook
Fig.6
[c]
Screw hole
Fig.4
N G
1
[d]
[a]
Hole
6
5
7
N G
Flat Surface
2
[n] : for BOSCH
[o] : for Others
Fig.8
Lever
4
[c]
Fig.9
Fig.5
Fig.7
[p]
3
Lower Base
-11-