Assembly - Greencut TDC600C Manuel D'utilisation

54

ASSEMBLY

ATTENTION: Do not connect the machine to the power supply until the assembly is complete.
Failure to comply could result in serious injury.
1. Place column (2) in base (1) and align the holes in the column mounting flange with the holes in the base.
Secure the parts with 3 screws (a). Tighten the screws securely with the appropriate wrench.
2. Move the table (3), smooth side up, towards the bottom of the column (2). Place the table on top of the base
and lock it by turning the locking lever (b) clockwise to the right until it is firm.
2
a
a
a
2
b
1
3