Konica Minolta DIMAGE G500 Mode D'emploi page 21

Table des Matières

Publicité

Préparation de l'alimentation (suite)
Merci de contribuer au recyclage des batteries lithium.
• Cet appareil utilise une batterie lithium.
• Cette batterie est recyclable et présente une ressource valorisable.
• Pour le recyclage des batteries usées recouvrir les contacts de ces batteries
afin d'éviter les risques de courts-circuits et donc d'inflammation et d'incen-
die ou placer ces batteries dans un sac en plastique étanche. Les confier
ensuite à un service de récupération et de recyclage. Des containers de
récupération sont disponibles dans de nombreux endroits et magasins.
Précautions concernant le recyclage.
Ne pas mettre les batteries en court-circuit. Risque d'arc électrique et d'incen-
die .
Ne pas retirer les revêtements (isolant, capot, container, etc.) Risque de fuite,
de surchauffe, d'explosion.
Ne pas démonter les batteries. Risque de fuite, de surchauffe, d'explosion.
Digital Camera:
Tested To Comply
With FCC Standards
FOR HOME OR OFFICE USE
approved by the party responsible for compliance could void the user's authority to operate
the equipment. This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio commu-
nications. However, there is no guarantee that interference will not occur in a particular ins-
tallation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Tested by the Minolta Corporation 101 Williams Drive, Ramsey, New Jersey
07446, U.S.A.
Do not remove the ferrite cores from the cables.
Industry Canada's Compliance Statement:
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
FCC Compliance Statement:
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation. Changes or modifications not
21

Publicité

Table des Matières
loading

Table des Matières