Resetting; Entering New Timings - Gateway 2000 VIVITRON 700 CPD-GF200 Mode D'emploi

Resetting

Entering new timings

Resolution
640 x 480
640 x 480
720 x 400
800 x 600
1024 x 768
1024 x 768
1280 x 1024
If you change your mind about customizing the screen
settings and wish to use the monitor's original set-
tings, simply press the RESET button to recall the
factory settings for brightness, contrast, horizontal and
vertical size, center, and pincushion for the mode cur-
rently in use.
If you press and hold the RESET button for 2 seconds,
the monitor recalls the factory settings for all adjust-
ments in all modes.
If you are going to use a video mode that is not one of
the 7 factory preset modes, you may need to fine tune
your monitor to get the best display possible for that
setting. You can adjust the monitor using the controls
described previously in this manual. Once you have
made the adjustments, they are automatically stored
and used whenever you select that mode.
The monitor stores up to 10 user-defined modes in its
memory. If you attempt to enter an 11th mode, it
replaces the first mode you originally entered.
Below are the factory settings that come preset with
the monitor. The monitor automatically detects what
frequency it is receiving and chooses the appropriate
mode.
H. Freq
31.47kHz
37.50
31.47
46.875
48.363
60.023
63.95
V. Freq Graphics Mode
59.94Hz VGA
75 VESA
70 DOS
75 VESA
60 VESA
75.029 VESA
60 VESA
Userﾕs Guide 17