Monacor TXA-1802CD Mode D'emploi page 8

The IR remote control for the player is supplied
with a battery . Prior to initial operation, remove the
foil from the battery holder . When pressing a but-
ton, always direct the remote control to the infrared
sensor (2) of the player . There must be no obstacles
between the sensor and the remote control .
If the remote control is not used for a longer time,
remove the battery as a precaution so that the re-
mote control will not be damaged in case the battery
should leak .
Replacing the battery: Push the latch of the battery
holder to the right (arrow 1 in the figure below) and re-
move the holder (arrow 2) . Remove the old battery and
insert the new battery (3 V button cell, type CR 2025)
into the holder with the positive pole pointing up-
wards . Push the holder back into the remote control .
➍
Batteries must not be placed in the household
waste . Always take them to a special waste dis-
posal (e . g . collection container at your retailer) .
To switch on /off the player, use the POWER but-
ton (1) .
Inserting a replay medium:
– Insert a CD with the lettering showing upwards into
the CD slot (A) until it is retracted automatically .
– Connect a USB storage medium (USB flash drive or
USB hard disk with separate power supply) to the
USB port (B) .
– Insert a memory card (notched corner upward and
contacts to the right) into the slot SD / SDHC (C) until
it engages . To remove the card, slightly push it into
the slot until it disengages .
To switch between the replay media, use the but-
ton MODE (4) . After reading in a medium, its replay
will start automatically . If a USB storage medium or a
memory card has been selected and is then removed,
the player automatically switches over to the CD player
mechanism . The same happens when a new CD is
retracted .
Control options and information on the display indi-
cations can be found in chapter 4 .1 .
8
4.1 Overview: Control elements and display
Control element
on the
remote control

on the player

Volume
3
VOL
✅
to set the volume
0 10
Selecting the replay medium
4
MODE
✅
M
to switch between CD, USB storage
medium and memory card
✅
MODE
Replay / Pause
5
PLAY
✅
to start the replay and
to switch between replay and pause
PLAY / I I
✅
Stop mode / Ejecting the CD
6
to stop the replay;
STOP/EJ
✅
in the stop mode: to eject the CD
When the CD has been ejected and has
EJECT
not been removed, press this button to
✅
retract the CD again.
STOP
✅
to stop the replay
Selecting folders
7
——— FOLDER ———
to go to the next folder (
✅
previous folder (
✅
to go to the next folder
FOLDER
Skipping titles /
8
Fast forward / reverse
to the beginning of the title; each time
PREV. — SKIP — F.WD
the button is pressed again, the player
✅
will go back one title at a time
fast forward / reverse: keep
pressed
REV. F.WD
to the beginning of the title; each time
✅
the button is pressed again, the player
will go back one title at a time
F.B F.F
fast forward / reverse: briefly press
✅
or
Notes
1. Selecting folders and titles during replay / pause:
Select the folder (brief indication of folder number and time 00:00): the
replay of title 1 in the folder will start. If required, go to another title.
Selecting folders and titles in the stop mode:
Select the folder and go to the desired title in the folder (indication of
folder number and title number in the folder). Start the replay.
2. Button : When this button is pressed while the player is in the pause
mode (during CD operation) or within a programmed title sequence,
the player will immediately go back one title.
Function
) or to the
)
: to go to the next title,
: to go to the next title,
. At the desired spot press
: to go
or
: to go
.