Safety Advice; General Maintenance - Flexlite FLX24L2H Manuel D'utilisateur

SAFETY ADVICE


If the light head come too hot, an integrated electronic device will turn down the light power at 25% of efficiency
on blinking mode. If the temperature still increases, the device will cut off the light automatically. Ensure the heat
sink is clean. If the problem persists, return the work light to an authorized service center.

When the battery becomes discharged, the light head will automatically turn down the light power at 25% of
efficiency to allow to the user several minutes to leave the dark area.
MAINTENANCE
WARNING:
When servicing use only identical FLEXLITE
replacement parts. Use of any other parts may
create a hazard or cause damage to the product.
WARNING:
Always wear safety goggles or safety glasses
with side shields when using compressed air to
clean work lights. If operation is dusty, also
wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline,
petroleum-based products, penetrating oils, etc.,
come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which
may result in serious personal injury.
BATTERIES
This work light is equipped with Li-Ion Polymer
rechargeable batteries. Length of service from each
charge will depend on the type of work you are doing.
The batteries in the housing have been designed to
provide maximum trouble-free life. However, like all
batteries, they will eventually wear out. Do not
disassemble housing and attempt to replace the batteries.
Handling of these batteries, especially when wearing
rings and jewelry, could result in a serious burn. Battery
Life: Batteries that lose 20% of their capacity must be
removed from service and disposed of properly. Return
FLEXLITE to your servicing center to replace the
battery.
FAN AND/OR HEAT SINK
MAINTENANCE
These Flexlite are made with an integrated cooling fan
designed to resist rain and dust. This fan and air flow
heat sink must be cleaned frequently to perform. Use
only a low air pressure gun to clean and remove any
dust. Don't use solvent, soap or cleaner. The unit is clean
when you can see across the heat sink.
WARNING:
Do no Do not immerse in water.
7