Flexlite FLX24L2H Manuel D'utilisateur page 6

WARNING:
Never disconnect the connector on the light head
unit when power is turned « on ».
OPERATION
WARNING:
Do not allow familiarity with work lights to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this work light.
The use of attachments
recommended can result in serious personal injury.
CAUTION:
To prevent damage to the built-in battery,
remove from the charger immediately if no LED
comes on. Return the work light and charger to
your nearest service center for maintenance or a
replacement.
CHARGING THE BATTERY
Battery for this work light is shipped in a low charge
condition to prevent possible problems. Therefore, you
should charge the battery until the light in front of the
charger turns green.
TO CHARGE
 Charge the battery pack only with the recommended chargers
(See « FEATURES » section on page 5).
 Connect the charger to a power supply.
 Turn off the light, connect the charger barrel Jack into the
outlet under the battery device or clip on the battery pack
inside the optional wall mount charger.
 After normal usage, a minimum of 4 hours of charging time
is required to be fully charged.
Use « Touch Pad » switch in front of the light head:
TO TURN WORKLIGHT ON:
DIME FROM 100% TO 50%:
DIME FROM 50% TO 25%:
FLASHING MODE:
TURN OFF:
Push and hold 1/2 second anytime
or accessories
Push and hold 1/2 second.
Push quickly one time.
Push quickly another time.
Push quickly another time
WARNING:
Keep FLEXLITE out of reach of children. The
work light may cause serious injuries. To avoid
possible strangulation, keep harness away from
children. This work light is not a toy.
 The charger will become slightly warm to the touch while
charging. This is normal and does not indicate a problem.
 Do not place the charger in an area of extreme heat or cold. It
will work best at normal room temperature.
 When the batteries become fully charged, unplug the charger
from the power supply.
 The charger will cut off automatically if battery is fully
charged as indicated by LED :

Charging :

Battery full : solid green LED

Error status : flashing red LED
not
WARNING:
Keep the charger and the work light out of reach of
children.
WARNING:
Do not try to open charger or work light. No parts can
be changed by user. To replace battery, return work
light and charger to an authorized service center.
IMPORTANT INFORMATION FOR
RECHARGING A HOT WORK LIGHT
When using the work light continuously, the batteries in
the battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes
before attempting to recharge.
NOTE: Refer to "CHARGING THE BATTERY" for
normal recharging of batteries. If the charger does not
charge your battery pack under normal circumstances,
return both the battery pack and charger to your nearest
repair center for electrical inspection. For the location of
your nearest repair center, please call 1-866-854-1411.
.
.
solid red LED
6