Varan BD-512 Manuel D'utilisation page 20

Description of use
The closed cab has a handle for easy transport. It has 4 rubber feet and the hatch
visible in the photo allows access to the electrical block.
The complete paint booth kit prevents the spread of the sprays released by your
airbrush. It can also be used to suck out fumes from welding, acrid vapours or
solvent vapours. The exhaust vent can thus easily get stuck in a window or door. By
drilling a partition or wall, the gases can also be expelled to the outside.
back of the spray booth.
Attach the 4 screws (unscrewed in the previous step) to the plastic sheath to connect
it to the booth and screw it back on. Then connect the sheath to the plastic sleeve.
The alternative installation can be done by hooking the plastic fitting to the ventilation grid. The removal
of the screws and grille as described is no longer necessary.
Maintenance description
- Cleaning is simple and should be carried out after each use for optimum service life of the unit.
- The unit must remain switched on for 2 - 6 minutes after each use, so that self-cleaning can take place!
- If the filter is completely soiled by large amounts of paint, it will no longer work and must be replaced
by a new filter.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
The 2 plastic covers (upper and lower) are easy to open, one opening upwards for
the upper element and downwards for the lower element.
To mount the exhaust air outlet, unscrew the 4 screws of the protective grille at the
20
T: 00352/26908036 – F: 00352/26908040
BD-512