Varan BD-512 Manuel D'utilisation page 17

BD-512
Introduction
Thank you for choosing this quality product. To minimize the risk of injury from electric shock or fire,
please always take a few basic safety precautions when using the unit. Please read these instructions
carefully and make sure that you understand them. Always use an earthed plug for connection to the
correct mains voltage. You will find the corresponding voltage on the type plate. If you have any doubts
about the connection and grounding, have it checked by qualified personnel. Never use a faulty cable.
Install the unit in a protected place, so that no one can climb over the cable and then fall over or damage it.
Never open this unit in a damp or wet location, or if you yourself are wet, and protect it from direct
sunlight. Ensure adequate ventilation in the surrounding area and avoid heat congestion. Unplug the
device before cleaning and use only a damp cloth for this purpose. Avoid using detergents, and make sure
that no liquid enters the electrical part of the device. There are no user-serviceable parts inside the motor
of the unit. Leave maintenance, balancing and possible repairs to qualified personnel or the 2-year
guarantee expires immediately! Keep these instructions in a safe place.
Safety instructions
WARNING:
The device is only allowed to be used with a protective circuit breaker with a rated tripping current of
30mA (according to VDE 0100 specification paragraphs 702 and 738). This device is not intended for use
by persons with restricted physical, mental or sensory abilities (including children) unless they are
supervised by a responsible person and are provided with the necessary information on how to use the
device. Children should be supervised to ensure that they do not play with the appliance.
WARNING:
- Make a visual check of the unit before each use. Do not use the unit if the safety equipment is damaged
or worn. Always remember to observe the safety precautions.
- Use the unit only for the purpose stated in this manual.
- You, as the user, are responsible for safety at work.
- If the cable or plug should be damaged for any external reason whatsoever, it must never be repaired but
replaced by new ones and this work must be carried out by qualified personnel.
- The 230 Volt alternating voltage stated on the nameplate of the device must correspond to the existing
mains voltage.
- Never lift, transport or secure the unit by the electric cable.
- Make sure that the electrical connections are not located in an area subject to flooding and protect them
from moisture.
- The user is responsible for complying with the safety and installation regulations for the area in which
the equipment is located. (If necessary, please consult a qualified electrician).
Varan Motors 17
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg T: 00352/26908036 – F: 00352/26908040