Philips Sonicare 2 Série Mode D'emploi page 10

Masquer les pouces Voir aussi pour Sonicare 2 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 48
ENGLISH
10
5
Gently move the brush head slowly across the teeth in a small back
and forth motion so the longer bristles reach between the teeth.
Continue this motion throughout the brushing cycle.
Note: To make sure you brush evenly throughout the mouth, divide the mouth
types only).
6
Brush each section for 30 seconds for a total brushing time of
2 minutes. Start with section 1 (outside top teeth) and then brush
section 2 (inside top teeth). Continue with section 3 (outside
(Fig. 6).
Note: After you have completed the brushing cycle, you can spend additional
time brushing the chewing surfaces of your teeth and areas where staining
occurs. You may also brush your tongue, with the toothbrush switched on or
off, as you prefer.
The Sonicare is safe to use on:
-
-
Note: When the Sonicare is used in clinical studies, the handle has to be fully
charged and the Easy-start feature must be deactivated.
-
A yellow battery level indicator indicates a low charge.
-
A green battery level indicator indicates a high charge.
-
The battery level indicator turns off when the battery is in between a
low and a high charge.
Note: When you hear 3 beeps and the yellow LED of the battery level
toothbrush should be recharged.
Note: To keep the battery fully charged at all times, you may keep the
Sonicare on the charger when not in use.
into 4 sections using the Quadpacer feature (see chapter 'Features'), (specific
bottom teeth) and finally brush section 4 (inside bottom teeth)
Braces (brush heads may wear out more quickly when used on
braces)
Dental restorations (fillings, crowns, veneers, implants)
Battery status (when handle is not on charger)
indicator flashes, this means the battery charge is below 10% and the

Publicité

Table des Matières
loading

Table des Matières